SAVÖX SV-1280SG Servo

Description
The SV-1280SG has been developed in close cooperation with the experienced Savöx development team and the best pilots in Europe. It is at the cutting edge of technology to offer maximum performance with the highest reliability and precision. The result of months of development, testing and joint work in the laboratory, on the test bench and in real operation for almost 100 operating hours makes the SV-1280SG a new milestone in servo technology. The all-aluminum housing provides the necessary robustness and durability and gives the SV-1280SG a high-quality and timeless look. The housing contains the latest motor technology on the market, including a completely newly developed 32-bit mainboard. This ensures an unprecedented resolution and precision that is clearly noticeable during operation. The actuating force of up to 55kg*cm at 8.4V with an actuating time of 0.12 sec/60° leaves hardly anything to be desired and implements every control command directly.
Special attention has been paid to the holding force around the zero position; here too, the SV-1280SG sets new standards and can only be moved with brute force. Of course, the SV-1280SG also has a soft start, which slowly brings the servo to the desired neutral position when switched on to protect the linkage. The Sanwa SSR mode is interesting for RC car drivers, for whom the SV-1280SG is of course also perfectly suited!
In addition to the standard accessories, the scope of delivery also includes a high-quality aluminum lever, which is available as an SH-82 accessory. Assembly instructions for the SH-8X lever: First tighten the two screws for clamping the sprocket evenly. Then fit the M2.5 screw to secure the lever. If this
If this sequence is disregarded, the lever may be overtightened! The SV-1280SG weighs a real 76 grams including the complete cable. The control frequency can be up to 333Hz, the center pulse is 1520us.
The SV-1280SG is therefore also suitable for use with modern gyros and stabilizer systems.

Features

• High end 32 bit servo with soft start in full aluminum housing 3x ball bearings
• Extremely powerful, extremely hard in the neutral position, reduced operating noise with maximum reliability
• High-voltage capable digital servo 4.8-8.4V, operation with 2s LiPo
• Dimensions (L/W/H): 40.3 x 20.2 x 38.2 mm Weight: 76 grams
• 0.14/0.12 sec/60 degrees and 45/55 kg*cm at 7.4/8.4 volts

Technical data

Actuating time S2/60° (sec): 0.12
Actuating time S1/60° (sec): 0.14
Width (mm): 20.2
Height (mm): 38.2
Voltage range: 4.8V-8.4V
Length (mm): 40.3
Actuating force S1 (kg*cm): 45
Actuating force S2 (kg*cm): 55
Weight (g): 76
Actuating frequency: Actuating frequency up to 333Hz, center pulse 1520us
High-voltage capable up to 8.4V: Yes
Recommended applications: Helicopter, airplane, car, boat
Motor type: Bell armature motor
Output teeth (number): 25
Ball bearing (number): 3
Voltage 1 (Volt): 7,4
Gear type: Steel
Housing type: Solid metal
Voltage 2 (Volt): 8,4
Classification: Standard

Scope of delivery

1x servo incl. servo lever and mounting screws