FMS Ranger V2 PNP green - 122cm mit Reflex Gyro

The Ranger V2 from FMS is a trainer model with a wingspan of 122 cm. The model is constructed from ultra-light EPO rigid foam material and offers exceptional lift at extremely low wing loading, even at slow speeds. Robust plastic struts give the wings additional strength during aerobatic maneuvers and the high-strength tripod landing gear makes handling on the ground child's play.

Reliable propulsion
Of course, a great aircraft also needs a great and, above all, reliable propulsion system. FMS has equipped the Ranger with a 1200KV outrunner on a Predator 20A controller, allowing the Ranger to go vertical on 3S if required.

Quick assembly
Only 6 (landing gear) or 10 (floats) screws are required to fully assemble the model. The model is assembled faster than the battery is charged.

FMS Reflex V3 stabilization system included
This model comes with an FMS Reflex system specially programmed for this aircraft. This electronic stabilization system is designed to assist the pilot with control commands without interfering with them. The Reflex system works with both PPM and SBUS inputs and works natively with all common remote control systems. If the Reflex system is assigned to a 3-channel switch, you can choose between 3 different modes:
• Stabilized mode: When the control sticks are released, the model is automatically brought into a neutral flight position, which offers beginners and inexperienced pilots in particular a great deal of safety in dicey situations.
• Optimized mode: The gyro system of the Reflex system counteracts external influences such as gusts of wind or crosswinds and keeps the model precisely in a stable position.
• Off: The reflex system can be switched off completely.
The FMS Reflex System is specially set for this model aircraft. No further programming is required. The FMS Reflex System can be bound to all receivers with at least 4 channels.

Features

• Reflex V3 stabilization system with gyro (compatible with all receivers with at least 4 channels) included in the scope of delivery
• Constructed from robust EPO hard foam material
• Powerful brushless motor, high-performance controller and 5 servos installed
• Metal landing gear included
• Includes 2-blade 10x5" propeller
• approx. 10-15 minutes flight time with 3S 1200mAh LiPo battery
• One-piece elevator for precise flight characteristics
• ready painted
• assembly of the model in 3-10 minutes
• including richly illustrated assembly instructions (German and English)

Technical data

• Wingspan: 1220 mm
• Length: 947 mm
• Flying weight: approx. 1200 g
• Wing area: 25.4 dm²
• Wing loading: 39.4 g/dm²
• Motor: Brushless 3136-KV1200
• ESC: Brushless 20A
• Servos: 4x 9g

Still needed

• Remote control: min. 4 channels
• Receiver: min. 4 channels
• Battery: 3S LiPo 1300mAh 25C
• LiPo charger