AGF-RC A24CHR SERVO

The AGF-RC A24CHR is a 10mm surface servo with an all-aluminum housing. The servo is HV capable and can be operated directly from a 2s LiPo (4.8 - 8.4V).
With an actuating force of 8kg, this small power proftz can be installed anywhere where space is limited but high actuating forces and a backlash-free gearbox are required.
With dimensions of 30 x 10 x 30.5 mm, it fits into all standard 10 mm servo shafts / frames.

The A24CHR is also programmable with the optional USB Inteface AGF-SP.

This requires a Windows computer with Windows 7 or 10. The servos are supplied directly via the USB port and only need to be plugged into the interface. In the software, for example, the soft start, the neutral point, the servo travels can be adjusted (larger and smaller) or the direction of rotation can be set. Furthermore, the Sanwa SSR mode can be activated if required, which is of particular interest to RC car drivers. The integrated overload cut-off can also be adjusted in 3 stages and you can select what should happen in the event of signal loss.

Of course, these are optional features, all servos can be operated as normal straight out of the box and do not need to be adjusted beforehand!

Technical data:

Actuating time S2/60° (sec): 0.080
Actuating time S1/60° (sec): 0.090
Width (mm): 10
Weight (g): 24.5
Length (mm): 30
Height (mm): 30.5
Voltage range: 4.8V-8.4V
Actuating force S1 (kg*cm): 7
Actuating force S2 (kg*cm): 8
Actuating frequency: Up to 333Hz, center pulse 1520us
Classification: Surface servo
High-voltage capable up to 8.4V: Yes
Ball bearing (number): 2
Recommended application: Airplane
Motor type: Bell armature motor
Output teeth (number): 25
Voltage 1 (Volt): 7.4
Gear type: Steel
Housing type: Full metal
Voltage 2 (Volt): 8.4