800 EC135 T2 HSM800 Yellow KIT

EC-135 T2 fuselage with Roban Compactor HSM-800 mechanics.
Careful workmanship and detailed cockpit. The full-scale design locates the cockpit in exactly the right place. The compact mechanics are integrated into the engine compartment, just like in a real helicopter. Consequently, it provides space for the front and rear cockpit seats. The pre-installed position light can be programmed with 9 different models. The helicopter is supplied with detailed operating instructions. Configuration and assembly is quick and easy, the mechanics are completely pre-assembled - but must be configured with the electronics. Only a screwdriver and Allen key are required to get it ready for operation.

Features

• 4-blade rotor head + carbon fiber rotor blades
• True-to-scale carbon fiber Fenestron blades included
• Numerous details : rivets and plates...
• Scale cockpit with seats (front and rear)
• Complete integrated/pre-installed position lighting system (controllable via auxiliary channel)
• Special CCPM mechanics integrated into the upper covers, just like the real helicopter
• The product is pre-assembled and requires little assembly work.

Technical data

• Fuselage length: 1765mm
• Length with blades: 1960mm
• Fuselage width: 355mm
• Height: 510mm
• Rotor diameter: 1660mm
• Length of blades: 750mm
• Fenestron diameter: 160mm
• Length A/C blades: 70mm
• Main shaft: 12mm
• A/C shaft: 5mm
• Main blades: 4
• Fenestron blades: 9
• Drive gear ratio: 1:13.8:4.7
• Flight time: ~5 minutes
• Flight weight: 8000g
• Main rotor speed: 1300 rpm
• Fenestron speed: 15600 rpm.

Scope of delivery

• EC-135 fuselage GRP molded and painted
• Aluminum landing gear
• mechanical HSM-800
• 4-blade main rotor head
• Fenestron tail rotor unit
• Main rotor blades
• Cockpit switched on
• Seat rows
• Lighting
• Scale parts
• Installation kit
• Instructions

Still needed

• 1x motor 750MX 450KV brushless outrunner, 12S capable - and up to 530kV
• 1x Controller 120A brushless HV, 12S capable
• 3x metal gear cyclic servo
• 1x metal gear tail servo
• 2x 6S 5000mAh battery
• 1x Gyro: 3 axis flybarless gyro (e.g. Microbeast)
• 1x remote control (min. 6 channels)
• 1x receiver (min. 6 channels)